True Line Fiber Tape (10 Rolls)

New 5" Spool - TrueLine fiber tape was developed to replace the high quality adhesive and easy removal with no residue that you have experienced in our trimming tapes of the past. Using the same high quality tape as the TrueLine wire tape but the wire has been replaced with a high strength braided fiber cutting filiment. Featuring a clear double-sided poly tape, TrueLine fiber tape is designed to provide easy application and removal with minimal residue.

The TrueLine products have similar characteristics to the edge cutting tapes we have provided in the past, with a unique adhesive incorporated in the TrueLine that produces superior results for a clean, fast cut, with virtually no residue.

100 ft. per roll of TrueLine fiber tape.

Tips for using TrueLine Fiber Tape

Application:

Before laying out the edge cutting tape make sure the area to be masked is clean and free of dirt, tar, and other contaminants.

Be sure to leave approximately 6 inches of extra tape at both ends of the wire tape to be used as handles to start cutting the edge of the liner.

For long straight runs, first attach the wire tape at your starting point. Unroll enough edge cutting tape to reach the end of the straight run and TUG the tape, putting only enough tension to straighten the line as you slowly begin to attach the other end to your end point (this TUG action will create a perfectly straight line as you hover about 3-5" above the end point). Now the wire tape should be lightly stuck to the surface with the option to re-lift and try again and again. Once the wire trim tape placement is satisfactory, proceed by TAPPING the wire tape down gently every 12" with your fingertips. Do not brush before TAPPING or the wire tape may move! After tapping wire tape in position, run your finger down the line to secure wire tape.

For clean corners be sure to stretch the edge cutting tape around the corner to prevent any material bleeding under the tape.

Try to use one long run of wire tape rather than short runs (example: Use one piece of wire tape around the outside of the tailgate rather than 4 separate pieces one for each side) This cut downs on the amount of wire tape required and makes for cleaner corners and faster unmasking.

Removal:

Pull cutting wire at approximately 45 degrees into bedliner (for uniform bevelled edge) and at 45 degrees in towards the cut line.

After pulling the TrueLine cutting filiment, SLOWLY remove adhesive tape body from substrate. Rapid removal may result in tape residue left on substrate..

Caution: All wire tape and filament bearing products contain fine cutting wire. Handle with care and always wear suitable protective equipment.